Faults And What To Do About Them - Bosch WTH852S8SN Installation And Operating Instructions Manual

Faults and what to do about them

en
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
ð in the display panel
and drying was inter-
rupted.
ç in the display panel.
The dryer will not start.
Creasing.
Water is leaking out.
Programme duration dis-
played changes during
drying.
Laundry is not dried cor-
rectly or is still too damp.
* Depending on the model
32
Cause/remedy
Empty the condensation container and press the Start button.
■
If the optional condensation drain has been installed, the drain hose may
■
be blocked or kinked.If the optional condensation drain has been installed,
the drain hose may be blocked or kinked. Check the hose for deposits and
flush the hose through. Lay the hose without any kinks.
Clean the fluff filter ~ Page 27.
■
Clean the EasyClean filter ~ Page 30.
■
Start button selected?
■
Mains plug plugged in or fuse/circuit breaker checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load
and adjust the programme length accordingly (except timed programmes).
After the end of the programme, warm laundry feels damper than it actu-
■
ally is. Spread the laundry out and allow the heat to disperse.
Fine tune the dryness level. This extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 23.
Select a programme with a longer drying time or increase the dryness
■
level. This does not increase the temperature.
Select a timed programme to add extra drying time for laundry that is still
■
damp ~ Page 21.
If you have exceeded the maximum load for the programme, the laundry
■
may not be dried properly.
Clean the moisture sensor in the drum. The sensor may become covered
■
in a fine layer of limescale or detergent and care product residue, which
then impairs its performance. This prevents your laundry from being dried
properly ~ Page 30.
Drying has stopped as a result of a power cut, because the condensation
■
container is full or because the maximum drying time has been exceeded.
Note: See also the laundry tips ~ Page 20.