Grid Remote Control; Pairing The Grid Device With The Chartplotter From The Chartplotter; Pairing The Grid Device With The Chartplotter From The Grid Device; Rotating The Grid Remote Input Device - Garmin GPSMAP 12 3 Series Owner's Manual

Radar Functions
Voice Command
Enable echo trail
Disable echo trail
Clear echo trail
Increase radar gain
Decrease radar gain
Increase radar range
Decrease radar range

GRID Remote Control

Pairing the GRID Device with the Chartplotter from the Chartplotter

NOTE: These steps are applicable to both the GRID device and the GRID 20 device.
Before you can pair the GRID 20 device with the chartplotter to make the data connection, you must supply
power using batteries, the included power cable, or a NMEA 2000 network connection.
Before you can pair the GRID device with the chartplotter, you must connect it to the Garmin Marine Network.
1 Select Settings > System > Station Information > GRID™ Pairing > Add.
2 Select an action:
• On the GRID remote input device, press SELECT.
• On the GRID 20 remote input device, press

Pairing the GRID Device with the Chartplotter from the GRID Device

NOTE: This is not applicable to the GRID 20 device.
1 On the GRID remote input device, press + and HOME at the same time.
A selection page opens on all of the chartplotters on the Garmin Marine Network.
2 Rotate the wheel on the GRID remote input device to highlight Select on the chartplotter you want to control
with the GRID remote input device.
3 Press SELECT.

Rotating the GRID Remote Input Device

For certain installation situations, you can rotate the orientation of the GRID device.
NOTE: This is not applicable to the GRID 20 device.
1 Select Settings > Communications > Marine Network.
2 Select the GRID device.
18
Function
Enables the echo trail
Disables the echo trail
Clears the echo trail
Increases the radar gain
Decreases the radar gain
Increases the radar range
Decreases the radar range
and until the remote control beeps three times.
Controlling the Chartplotter