Table of Contents
Advertisement
en operation
¡ Remove curtain fittings and lead
strips
¡ Wash small or particularly delicate
items in a mesh washing bag
¡ Load the laundry unfolded into the
drum
¡ Spin the laundry before drying
operation
12 Basic operation
operation
12.1 Switching on the appli-
ance
Requirement: The appliance has
been correctly installed and connec-
ted.
→ "Installation and connection",
Page 12
Press
.
▶
The switch-on process takes a few
seconds.
Note: The lighting for the drum goes
out automatically.
12.2 Setting a programme
Turn the programme selector and
1.
set the required programme.
→ "Programmes", Page 24
If required, adjust the programme
2.
settings.
→ "Adjusting the programme set-
tings", Page 28
12.3 Adjusting the pro-
gramme settings
Depending on the programme and
programme progress, you can adjust
or activate/deactivate the settings.
Requirement: A programme is set.
→ "Setting a programme", Page 28
Adjust the programme settings.
▶
→ "Buttons", Page 21
28
Note: The programme settings are
not saved permanently for the pro-
gramme.
12.4 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 24
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 27
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.5 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press
.
▶
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "-0-" .
Note: If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.6 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press
.
1.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
Advertisement
Table of Contents
