Marvel 3SWCE-BB-G Installation Instructions
3.0 custom wood frame designer door
Hide thumbs
Also See for 3SWCE-BB-G:
- Datasheet (1 page) ,
- Installation, operation and maintenance instructions (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Marvel 3SWCE-BB-G
Summary of Contents for Marvel 3SWCE-BB-G
- Page 1 A Division of Northland Corporation...
- Page 2 1. A #8 PAN HEAD WOOD SCREW SHOULD BE USED TO PROPERLY SECURE THE WOOD FRAME. A TOTAL OF 8 SCREWS WILL BE NEEDED. FOR A 3 1/2 INCH TOE KICK OR 7 SCREWS FOR A 4 INCH TOE KICK. 2.
- Page 3 FOR A 3.5 INCH TOE KICK (COVERS THE ENTIRE DOOR EXTRUSION) Ø0.25 X 0.375 DEEP HINGE SCREW CLEARANCE HOLE. LOCATE AND DRILL USING DOOR HINGE HOLE AFTER THE DOOR HAS BEEN ALIGNED TO THE UNIT AND WHEN THE WOOD IS POSITIONED ON DOOR.
- Page 4 1. IF THE DOOR IS ATTACHED TO THE UNIT, REMOVE IT BY UNSCREWING THE TOP ALLEN HEAD SET SCREW AT THE TOP HINGE. REMOVE THE DOOR BY ANGLING THE DOOR OFF OF THE BOTTOM HINGE PIN. 2. PEEL BACK DOOR GASKET TO EXPOSE THE SCREW HOLES. 3.
Need help?
Do you have a question about the 3SWCE-BB-G and is the answer not in the manual?
Questions and answers