Table of Contents
Advertisement
USER GUIDE
QUICK START GUIDE
Door Swing
2-1/8" Min.
(54 mm)
90°
Door Swing
Units have a zero clearance for the door to open 90°,
when installed adjacent to cabinets.
Stainless Steel models require 2-1/8" (54 mm) door
clearance to accommodate the handle if installed next to a
wall.
Door Swing
Wall
15" Models
Door Adjustments
HINGE COVER
Hinge cover included with the literature bag is optional.
To install hinge cover:
1.
Press hinge cover squarely over hinge.
DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or is not sealing
properly. If the door is not sealed, the unit may not cool
properly, or excessive frost may form in the interior.
NOTICE
Properly aligned, the door's gasket should be
firmly in contact with the cabinet all the way
around the door (no gaps). Carefully examine the
door's gasket to ensure that it is firmly in contact
with the cabinet. Also make sure the door gasket
is not pinched on the hinge side of the door.
To align and adjust the door:
1.
Gently pry off hinge c ver from top of unit.
2.
Loosen (do not remove) top and bottom hinge screws
using a Torx T-25 screwdriver.
3.
Align door squarely with cabinet.
4.
Make sure gasket is firmly in con act with cabinet all
the way around the door (no gaps).
5.
Tighten bottom hinge screws.
6.
Tighten top hinge screws and replace hinge cover.
6
u-line.com
Hinge Cover
Advertisement
Table of Contents
