Maintenance And Cleaning; Environment Protection - Jata electro FILTRA PLUS FR680 Instructions Manual

"RESET" button (13)
• The fryer has a safety device that automatically disconnects it if it should overheat. It may also overheat if the
appliance is connected without oil in the tank or if the oil level is under the minimum level shown on the tank.
• If this were to happen you must proceed to reset the safety device. To do so, wait for the oil and the resistance
to cool completely.
• Press with a small screwdriver on the button marked "RESET" until you hear a "click" indicating that the
thermostat has rearmed. Once this operation done, the deep fryer will operate normally.
• If the device were to disconnect itself repeatedly, the appliance should be revised by an authorised technical
service.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning it, ensure the fryer is unplugged from the mains.
• Remove the head (4) with the special mesh (3) by pulling upwards.
• The basket, the special mesh and the tank can be cleaned with soap and water, taking care to rinse and dry
them carefully afterwards.
• The lid can be cleaned with a dampened cloth and do not immerse in water neither into the dishwasher.
• The resistance may be cleaned with a damp cloth. Never immerse in water.
• Clean the outside of the appliance with a damp cloth.
• Do not use chemical or abrasive products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
12 12