Table of Contents
Advertisement
Fault
The drying time is too
long.
"AIr" and the appli-
ance is not respond-
ing to operation.
Water is leaking from
the appliance.
The laundry is too
damp.
Cause and troubleshooting
Ensure that the ambient temperature is above 16
▶
°C or start the next drying process within 2 hours.
→ " Technical data", Page 56
Remote start is activated and the ambient temperature
is lower than 16 °C.
Ensure that the ambient temperature is above 16
▶
°C or start the next drying process within 2 hours.
→ " Technical data", Page 56
The ambient temperature is low and the base unit fil-
ter is damp.
→ "Cleaning the filter system on the base unit",
1.
Page 29.
Dry the filter thoroughly after cleaning.
2.
→ "Closing the base unit", Page 44.
3.
→ "Switching off the appliance", Page 29.
4.
→ "Switching on the appliance", Page 28.
5.
→ "Starting the programme", Page 29.
6.
Automatic self-cleaning function rinses the appliance's
heat exchanger.
Not a fault.
1.
Do not pull out the condensation tank.
2.
Do not cancel the programme.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The seal for the heat exchanger cover is dirty.
Clean the seal for the heat exchanger cover.
▶
→ "Cleaning the filter system on the base unit",
Page 29
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The lever for the heat exchanger cover is not closed
correctly.
Ensure that the lever for the heat exchanger cover
▶
is closed correctly.
→ "Closing the base unit", Page 44
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 24
There has been a power cut.
Troubleshooting en
51
Advertisement
Table of Contents
