Marantz ST7001 Specification Sheet
  1. Manuals
  2. Brands
  3. Marantz Manuals
  4. Tuner
  5. ST7001
  6. Specification sheet
Marantz ST7001 Specification Sheet

Marantz ST7001 Specification Sheet

Rs232c control specification
Hide thumbs Also See for ST7001:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Service Manual, User Manual
RS232C Control Specification
Category
Document Version
Date
Number of Page
All rights are reserved. Reproduction in whole or in part is prohibited without the written consent of copyright.
All specifications might be subject to change without notice.
Marantz
for
ST7001
:
Stereo Tuner
:
1.01
:
2006/08/10
:
14
Marantz America, Inc. 2006
ST7001 RS232C Control
Specification: Rev.1.01

Advertisement

Table of Contents
loading

Related Manuals for Marantz ST7001

Summary of Contents for Marantz ST7001

  • Page 1 Category Document Version Date Number of Page Marantz America, Inc. 2006 All rights are reserved. Reproduction in whole or in part is prohibited without the written consent of copyright. All specifications might be subject to change without notice. Marantz ST7001 Stereo Tuner 1.01...

  • Page 2: Table Of Contents

    RS232C Control Specification Global Description ... 3 1-1. Overview... 3 1-2. Block Diagram... 3 1-3. Interface connection specification of the product... 3 1-4. Assumptions and Dependencies... 3 Detailed Description... 4 2-1. Connection format ... 4 2-1-1. Physical connection... 4 2-1-1-1. Data transmission sequence from Host to Slave ...

  • Page 3: Global Description

    RS232C Control Specification 1. Global Description 1-1. Overview A Host controller can control or watch out the product as a Slave very easily via the communication cable. 1-2. Block Diagram HOST (Controller) * The product has D-SUB 9pin male connector. * RS232C cable has to be the Straight type.

  • Page 4: Detailed Description

    RS232C Control Specification 2. Detailed Description The interface specification between the product and a Host controller is described below. 2-1. Connection format 2-1-1. Physical connection Host (Controller) 2-1-1-1. Data transmission sequence from Host to Slave Host (Controller) 1. Host starts a data transmission from TxD. 2.

  • Page 5: Transmission Data Format

    RS232C Control Specification 2-2. Transmission data format 2-2-1. Transmission data format from Host to Slave There are two kinds of transmission data form from Host shown below. 2-2-1-1. Form1: Command Command is a data that requests some status change. Start character COMMAND End character (CR) : 0Dh Start...

  • Page 6: The Transaction Sequences And The Regulations

    RS232C Control Specification 2-3. The transaction sequences and the regulations 2-3-1. The transaction sequences The transactions have three kinds of sequence. *A transaction is a Command from Host then Slave will be an answer by Status answer, ACK or NAK. *A transaction is a Status request from Host then Slave will be an answer by Status answer or NAK.

  • Page 7: Examples Of The Handshaking Flowchart

    RS232C Control Specification 2-3-5. Examples of the handshaking flowchart 2-3-5-1. Example of successful handshaking C o m m a n d S ta tu s r e q u e s t The product can reply ACK instead of related status, if the product can not send the related status immediatly.

  • Page 8: Recommendations Of Command, Status And Layer Definition

    RS232C Control Specification 3. Recommendations of Command, Status and Layer definition All Commands, Statuses and Layers will be defined other specific document. [MANDATORY] The product MUST have Commands and the Statuses same as a remote controller buttons (IR controller) of the product. All Commands are required working by discreate as ON/OFF commands.

  • Page 9: Definitions Of Command, Status And Layer

    RS232C Control Specification 4. Definitions of Command, Status and Layer This section is told how to define “Command”, “Status” and “Layer” of this product. 4-1. Commands This chapter will show the commands of this product. 4-1-1. Normal Command list TOGGLE POWER TOGGLE (work on same as RC)
  • Page 10 RS232C Control Specification VALUE (work on same as Frequency DOWN (work on same as Auto-UP Auto-DOWN VALUE (work on same as Preset DOWN (work on same as TOGGLE (work on same as Tuner mode OFF(MONO) ON(AUTO) (work on same as Numeric Key [1] (work on same as Numeric Key [2]...
  • Page 11 RS232C Control Specification GROUP DOWN GROUP UP GROUP A GROUP B GROUP C GROUP D GROUP E GROUP F GROUP G GROUP H GROUP I Memory Group GROUP J GROUP K GROUP L GROUP M GROUP N GROUP O GROUP P GROUP Q GROUP R GROUP S...

  • Page 12: Status Request And Status Answer List

    RS232C Control Specification 4-2. Status request and Status answer list 4-2-1. Normal Status request and Status (answer and feedback) list Status request POWER “PWR:?” BAND “BND:?” SLEEP “SLP:?” DIMMER “DIM:?” DISPLAY “DIP:?” Status request Tuner Frequency “TFQ:?” Tuner Preset “TPR:?” Tuner mode “TMD:?”...

  • Page 13: Special Status Request And Status Answer List

    RS232C Control Specification Status request Memory Group “MGP:?” Status request XM Category Search “CAT:?” Status request XM Channel Name “CHN:?” XM Artist Name “ARN:?” XM Song Title(Name ) “SON:?” XM Signal Status “SST:?” 4-2-2. Special Status request and Status answer list Status request Auto status feedback “AST:?”...

  • Page 14: Layer Of The Statuses

    XM Song Title XM Signal Status Status Auto status feedback Read Host I/F Software version Revision history Rev. Date Owner 1.0 08/04/06 Marantz America, Inc. 1.01 08/10/06 Marantz America, Inc. RS232C Control Specification Status “PWR:” “BND:” “SLP:” “DIM:” “DIP:” “TFQ:”...

Table of Contents