Table of Contents
Advertisement
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
ð on the display panel
and drying has been inter-
rupted.
ñ on the display panel.
Dryer will not start.
Creasing.
Water is leaking out.
Programme duration dis-
played changes during
drying.
* Depending on the model
Cause/remedy
Empty the condensation container and press the Start button.
■
Clean the filter in the condensation container ~ Page 40.
■
Run the intensive appliance care programme ~ Page 42.
■
Check that there is no debris blocking the air shaft or the supply line to the
■
pump.Open the maintenance flap to remove any debris ~ Page 45.
If the optional condensation drain has been installed, the drain hose may be
■
blocked or kinked.If the optional condensation drain has been installed, the
drain hose may be blocked or kinked. Check the hose for deposits and
flush the hose through. Lay the hose without any kinks.
Clean the fluff filter ~ Page 35.
Start button selected?
■
Mains plug plugged in or fuse/circuit breaker checked?
■
Programme selected?Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table.
Remove clothing from the dryer as soon as the drying programme has
■
ended. Creasing occurs when clothing is left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
■
Check that there is no dirt or debris on the cover's seal. Clean the cover's
■
seal ~ Page 45.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length accordingly (except timed programmes).
Faults and what to do about them
en
47
Advertisement
Table of Contents
