Troubleshooting - Respekta WKS122-19 User Manual

Troubleshooting

The appliance makes
lots of noise?
Liquid flowing sound
inside the cabinet?
The appliance does
not start?
Compressor runs
continuously?
Door does not seal
tightly?
The appliance does
not cool sufficiently?
Unpleasant smells
inside cabinet?
Condensate on the
glass door?
The light is not
working?
 Please adjust the front foot, keep the
appliance leveling.
 Please keep the appliance a bit space from
walls.
 It is normal because of the refrigerant
working inside.
 Make sure the appliance is connected to
the power properly.
 Make sure switch on the power.
 The compressor re-starts after 5 minutes
for a power cut.
 If no cold is being produced, call the
retailer's after-sale service.
 After long time use, the door seal might get
stiff & distorted partially.
1. Heat the door seal with hot-wind blower
or hot towel.
2. The door seal get softened and close the
door.
 Please adjust temperature setting.
 Keep the appliance away from sunlight or
heat.
 Please do not open the door frequently.
 A little bit plastic smell for newly-buy
appliance is normal and will disappear after
a short time.
 Clean the compartment and ventilate it for a
few hours.
 Please do not open the door frequently or
for a long time.
 Please do not set the temperature too low.
 High ambient temperature and humidity
would cause condensate.
 Check the power supply first.
 Call the retailer's after-sale service if the
light is broken.
12