I-G3N Z Series Reference Manual page 10

RS232 communication port
• RS232 communication port: (RJ11 port) comply with RS232 protocol (baud rate: 9600), for
manufacturers or professional engineers debugging or service.
Port definitions
Multi-device parallel connection 1 and Multi-device parallel connection 2
• Multi-device parallel connection: The same RJ45 port, two RJ45 parallel. Comply with RS485
protocol (baud rate: 9600), used for parallel communication between batteries.
Port definitions
Reset Button
• When Battery is in sleep mode, press the key for 3S and release it, the Battery will be
activated, and the LED indicators will light up from left to right, and then showing the SOC of
the battery.
• When Battery is in the active state, press the key for 3S and release it, the Battery will go into
sleep mode, and the LED indicators will light up from right to left and then all the indicators
will be off.
• When Battery is in the active state, press the button for 6S and then release, the battery
parameters are restored to factory settings, and all LED lights are on for 1.5 seconds.
NOTE
• If there are other batteries in the output state in parallel application scenario, the current battery cannot be set to sleep through the reset
button at this time, because it will be charged and awakened by other batteries with normal output.
INTRODUCTION
RJ11 Pin
1
2
3
4
5
6
RJ45 Pin
1
2
3
4
5
6
7
8
Function
NC
RS232-GND
RS232-TX
RS232-RX
RS232-GND
NC
Function
RS485-B
RS485-A
RS485-GND
NC (No connect)
NC (No connect)
RS485-GND
RS485-A
RS485-B
8