Panasonic WX-ST200 Operating Instructions Manual page 21

3
Pair the microphone
With the microphone powered on, keep the [REG]
button pressed for at least two seconds to start
pairing (the [PWR] indicator will blink orange).
If pairing is completed successfully, the [PWR]
indicator on the microphone will switch to the
normal status according to the remaining battery
level (green, orange, or red), and the [REG]
indicator on the paired channel on the wireless
receiver / extension receiver lights green for one
second and then goes off.
⿟ If pairing could not be completed successfully,
the [PWR] indicator on the microphone will blink
red. In that event, place the microphone as close
as possible to the antenna and try pairing it
again. (Pairing may fail if the microphone is too
far away from the antenna or under bad
connection conditions.)
Important
4
Place the battery cover back on
Place the battery cover onto the microphone and turn it right to fix it.
⿟ While the microphone is in use, the [REG] button of the corresponding
channel on the wireless receiver or extension receiver is disabled. Turn the
currently paired microphone power OFF, then you can pair a different
microphone to the channel that is already in use.
⿟ The wireless receiver / extension receiver cannot enter pairing mode on
multiple channels simultaneously.
⿟ When a channel on the wireless receiver / extension receiver is in pairing
mode, all other channels can still be used as normal.
Power indicator
Register button
21