Daytona 89238 Instructions

INSTRUCTION
Thank you for purchasing the DAYTONA STEERING DAMPER KIT.
Product Features
- Stabilizes steering especially at high speed.
- Prevents the front forks from being twisted at high speed
cornering.
- Bolt-on mount. The kit includes application specific brackets and
all hardware easy mounting.
1. Read all instructions before use.
2. After installation, check to see if all the parts are correctly
installed, and see if all the screws are torqued properly.
3. Do not adjust the damper while riding.
4. Periodical inspection of the installed parts is required every
500km (300mile). If anything unusual may be found while
riding, pull over at a safe place to check.
Install
Before installing, turn the adjustable knob
counter-clockwise to the end.
Softer
Fig.1
Fig.2
F W
D .
Fig.3
Install FORK BRACKET
F W
D .
Fig.4
FLTRX:
Remove the left housing cover
(see Fig.2)
FLHX:
Remove the Outer Fairing Skirt &
Turn Signal Brackets.
(see Fig.3)
Place the FRONT FORK
BRACKET(#3) on the left
side above the triple tree.
The distance between the
FRONT FORK
BRACKET(#3) and triple
tree is 54mm(2.1").
54mm
(2.1")
STEERING DAMPER KIT
for Harley Davidson FLTRX 2017up
F W
D .
Fig.5
4. SPACER
5. M8x30 CAP SCREW
Apply thread locking fluid
1. DAMPER BODY
Adjust the FRONT FORK
BRACKET(#3) position. Make sure
FRONT FORK BRACKET(#3) & DAMPER
BODY(#1) do not hit motorcycle frame neck
when turning the handle to the leftmost position.
(see Fig.6)
Install FRAME BRACKET
F W
D .
2. FRAME BRACKET SET
6. M6x45 CAP SCREW (4)
Round shape
Position the bracket so the round cutout clears
the bolt on the cylinderhead as shown.
The bracket must not contact the cylinder head or bolt.
(see Fig.8)
89238 / 200220
Connect the DAMPER
BODY(#1) with SPACER(#4).
Fig.6
Fig.7
Screw
Fig.8
PAGE 1 of 2