General Information; Rear Sliding Door Removal And Installation - Tyler TLM Installation & Service Manual

Installation & Service Manual
Grease and oil
*
Use of proprietary names is intended only to indicate a type of cleaner, and does not constitute an endorsement, nor is
omission of any proprietary cleanser to imply its inadequacy. It should be emphasized that all products should be used
in strict accordance with instructions on package.
**
In all applications a sponge or fibrous brush or pad are recommended. DO NOT use ordinary steel wool, steel brushes,
chlorine bleach or products containing bleach for cleaning or sanitizing stainless steel.

GENERAL INFORMATION

Rear Sliding Door Removal
and Installation
The sliding doors come installed from the
factory in the door frames. These doors are
removable for cleaning and to aid in case
maintenance. NOTE: DO NOT FULLY
IMMERSE DOORS WHEN CLEANING. The
inner and outer doors are marked with labels
from the factory. If the doors are not labeled,
the inner door can be identified as having the
limiter stops on it.
1. Remove the outer door (1) by sliding it to
the right end of the door frame (2) (within
an inch of being closed).
April, 2007
Get user manuals: See SafeManuals.com
Organic solvents such as
carbon tetrachloride, tri-
chlorethylene, acetone, kero- and/or toxic. Observe all
sene, gasoline, benzene,
alcohol and chlorethane n.u.
Rub with a cloth. Organic
solvents may be flammable
precautions against fire.
Do not smoke while vapors
are present. Be sure area
is well ventilated.
2. Firmly grasp both sides of the outer door
(1) and lift into the upper track (3) until it
clears the lower track (4).
3. Tilt out the bottom of the outer door (1)
so it can clear the lower track (4).
4. Lower the outer door (1) out of the upper
track (3) to remove it from the case.
5. Repeat steps 1 thru 4 to remove the
inner door (5).
6. Reverse the above steps to replace the
inner and outer doors (5 and 1).
TLM, TLF, TLD
Satisfactory for use on all
finishes.
Page 25