Table of Contents
Advertisement
Installation & Service Manual
2. Remove front kickplate.
3. Remove screws and front lower cladding. See page 22.
4. Remove screws from top and bottom of front upper cladding and remove front upper cladding.
5. After cleaning, replace front upper cladding and remaining front components in the
reverse order.
Cleaning Instructions
TYLER Refrigeration does not recommend the use of high pressure cleaning equipment on
service style cases!! The sealing of front glass and end joints is critical in these cases and
high pressure cleaners can penetrate and/or damage these seals. Damaged seals allow
water leaks and/or air leaks that can cause poor case refrigeration.
• When cleaning this case, try not to introduce water into the case faster than it can be
carried away by the waste outlet.
• Liquid chlorine bleach is corrosive to metals. The use of bleach or products containing
bleach will damage metal surfaces and void the case warranty.
• Sanitize the case with Quaternary Ammonium Solutions (ex: KAYQUAT II, J-512 Sanitizer,
SANIQUAT 512, tec...) approved per 21CFR 178.1010, followed by adequate draining and
air drying. These solutions may be obtained from Kay Chemical Co., Johnson Wax
Professional, Coastwide Laboratories, etc....
• Always use a soft cloth or sponge with mild detergent and water to clean the front glass.
Never use abrasives or scouring pads to clean glass. They can scratch and/or damage
the glass.
See "General (UL/NSF) I&S Manual" for case cleaning instructions.
Stainless Steel Cleaning Methods
The cleaning data in the following stainless steel cleaning chart was supplied by AISI. The information was supplied by
Prime Metals Division, Alumax Aluminum Corporation.
TYPE OF CLEANING
Routine cleaning
Smears and finger-
prints
Stubborn spots and
stains, baked-on
splatter, and other light
discolorations
April, 2007
Get user manuals:
See SafeManuals.com
WARNING
CAUTION
CLEANING AGENT*
Soap, ammonia or deter-
gent and water.
Arcal 20, Lac-O-Nu, Lumin
Wash O'Cedar Cream
Polish, Stainless Shine
Allchem Concentrated
Cleaner
Samae, Twinkle, or Cameo
Copper Cleaner
Grade FFF Italian pumice,
whiting or talc
Liquid NuSteel
APPLICATION METHOD**
Sponge with cloth, then
rinse with clear water and
wipe dry.
Rub with cloth as directed
on the package.
Apply with damp sponge or
cloth.
Rub with damp cloth.
Rub with damp cloth.
Rub with dry cloth. Use a
small amount of cleaner.
TLM, TLF, TLD
EFFECT ON FINISH
Satisfactory for use on all
finishes.
Satisfactory for use on all
finishes. Provides barrier film
Satisfactory for use on all
finishes.
Satisfactory for use on all
finishes if rubbing is light.
Use in direction of polish lines
on No. 4 (polished) finish.
May scratch No. 2 (mill) and
No. 7 and 8 (polished) finishes.
Use in direction of polish lines
on No. 4 (polished) finish.
May scratch No. 2 (mill) and
No. 7 and 8 (polished) finishes.
Page 23
Advertisement
Table of Contents
