Toro E-Z Vac 79346 Operator's Manual page 13

Figure 13
1. Nut
2. Existing hitch bracket
2. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch) as shown in
Figure 14
1. Locknut (5/16 inch)
3. Remove the existing 2 self-tapping screws from
the bottom of the machine frame
4. Loosely install the pivot frame to the machine
frame using 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch) as shown in
g308798
3. Bolt
Figure 14.
g308799
2. Carriage bolt (5/16 x 3/4
inch)
(Figure 16).
Figure 15.
1. Locknut (5/16 inch)
5. Position the pivot frame upward, and secure the
pivot frame to the bottom of the machine frame
using 2 self-tapping screws (5/16 x 3/4 inch) as
shown in Figure
1. Self-tapping screw (5/16 x
3/4 inch)
6. Tighten the 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch) as shown in
7. Install the bent, flared end of a rod into the keyed
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame
(Figure 17).
Note:
Repeat this step for the right side of the
machine.
11
Figure 15
2. Bolt (5/16 x 1 inch)
16.
Figure 16
2. Pivot frame
Figure 15.
g302477
g308797