Daytona 80675 Instruction Manual

INSTRUCTION MANUAL
Thank you for purchasing DAYTONA STEERING DAMPER KIT.
Product Features
- Stabilizes steering especially at high speed.
- Prevents the front forks from being twisted during high speed
cornering.
- Bolt-on mount. The kit inclides application specific brackets and
all hardware for easy mounting.
1. Read all instructions before use.
2. After installation, check to see if all the parts are correctly
installed, and see if all the screws are torqued properly.
3. Do not adjust the damper while riding.
4. Periodical inspection of the installed parts is required every
500km (300mile). If anything unusual may be found while
riding, pull over at a safe place to check.
Install
*Install stabilizer on the left side of motorcycle.
Fig.1
Before installing, turn the adjustable knob
counter-clockwise to the end.
Softer
Install FORK BRACKET
1. Attach fork bracket(#2) on the left front fork tube.
M6X20 CAP SCREW
#2. FORK BRACKET SET
L-FORK TUBE
LOWER TRIPLE CRAMP
FW D.
Fig.2
3-3/4" (95.25mm)
FW D.
Fig.3
STEERING DAMPER KIT
for H-D XL1200/883 ('07~) ,
XL1200X FOURTY-EIGHT(~'15)
The orientations of brackets for models with different fork pitches are
shown below.
#2. FORK BRACKET
10 degrees
LOWER TRIPLE CRAMP
30 degrees
Fig.4
Install FRAME BRACKET
2. Remove the front side installation bolt of fuel tank.
3. Remove the installation bolt of the ignition coil.
6. Install a supplied frame bracket(#3) over the ignition coil bracket
on front side.
7. install a supplied spacer(#4) in backside bitween ignition coil
bracket and ignition coil, and then fix the ignition coil with
cap screws(#10).
(STOCK)
FW D.
#3. FRAME BRACKET
Fig.5
80675 / 84758 : 20210915
7" (177.8mm)
8.5" (215.9mm)
IGNITION COIL BRACKET (STOCK)
PLATE NUT (STOCK)
#4. SPACER
φ6.5ｘφ20ｘ5mm
IGNITION COIL
#10. CAP SCREW
UNC 1/4-20 x 2"
PAGE 1 of 2