Video; Hdmi; Hdmi Troubleshooting - Marantz NR1501 User Manual

ENGLISH
TROUBLESHOOTING

VIDEO

Symptom Cause
• The monitor TV connection,
input switching, etc., are not set
up correctly.
No image on the
• The unit has an HDMI
monitor TV.
connection to the source
component, but no HDMI
connection to the monitor TV.
The audio or
the image does The input cables are not correctly
not match the connected.
selected source.
• The video recording component
jack does not match the source
Cannot record to a
component jack.
VCR, etc.
• A copy-protected signal is being
received.
When special playback is
performed by the video deck, the
The converted
conversion may not be carried out
video signals are
normally, causing the video signals
disturbed.
to be disturbed and preventing the
images from being shown.
36
Solution Page
• See the monitor TV's instruction
manual.
11
• Make an HDMI connection to
the monitor TV.
Connect the cables properly,
referring to the connection 9, 10, 11
diagram.
• Make sure the recording
component jack matches the
source component jack. (Video
input)
10
• Video signals that include copy-
protected signals cannot be
recorded.
Connect a monitor TV using the
same format (video or component) 10
as the source component.

HDMI

Symptom Cause
The HDMI cable is improperly
connected.
The unit is connected with a non-
spec HDMI cable.
The connection between
components over an HDMI
connection has not been
authenticated.
There is no picture
with the HDMI
connection.
The HDMI settings are incorrect.
The unit is connected to the video
component (TV, projector, etc.) by
DVI connector.
The power to the unit is turned off.
(HDMI connections are not enabled
when the unit is in STANDBY mode.)
It takes time for
The connection is being
the image to be
authenticated between components
displayed over an
on the HDMI connection.
HDMI connection.
The HDMI settings are incorrect.
There is no audio
playback over an
HDMI connection.
ON has been set for HDMI AUDIO
OUT on the SYSTEM SETUP menu.
Solution Page
Check the HDMI cable connection. 11
Use of a cable no longer than 5
meters is recommended to ensure
11
stable operation, prevent picture
degradation, etc.
Turn the power on again to all
the components on the HDMI −
connection.
Make sure the unit's HDMI
−
settings are correct.
Set the unit for HDMI input, as
explained in the instruction manual
−
of the video component (TV,
projector, etc.).
Make settings to enable HDMI
output, as explained in the
instruction manual of the source 19
device (Blu-ray disc player, Set Top
Box, etc.).
Match the resolution for both
components, as explained
in the instruction manual of −
the component on the HDMI
connection.
Connect an HDCP-compatible
−
video component.
Turn on the main power to the unit. 12
Some HDMI components require
time for authentication. There is −
nothing wrong with the unit.
Make settings to enable HDMI audio
output, as explained in the instruction
19
manual of the source device (Blu-ray
disc player, Set Top Box, etc.).
Set so that the HDMI audio output
setting matches the signals
supported by the unit, as explained
−
in the instruction manual of the
source device (Blu-ray disc player,
Set Top Box, etc.).
No sound is heard from the unit
when ON is set for HDMI AUDIO
19
OUT. Select OFF as this menu
item's setting.