Connecting The Antennas; Connecting Of Ac Power Cable; Basic Operation; Amp Operation - Marantz NR1501 User Manual

ENGLISH
BASIC CONNECTIONS

CONNECTING THE ANTENNAS

CONNECTING THE SUPPLIED ANTENNAS
The supplied antennas are for indoor use only.
Black White
GND GND
AM AM
Notes
• During use, extend the FM antenna and move it in various directions until the clearest sound is received.
Fix it with push pins or similar implements in that cause the least amount of distortion.
• Set in the direction and position it to where you receive the clearest sound. Put it as far away as possible from
the unit, televisions,speaker cables and power cable.
CONNECTING AN OUTDOOR ANTENNAS
If you experience poor reception quality, an outdoor antenna may improve the quality.
Keep the antenna from noise sources (neon signes, busy roads, power lines, transformers, etc)
FM External
Antenna
Notes
• Do not remove the AM loop antenna.
• Do not connect the supplied FM antenna.
• The GND terminal on this unit does not function as a safety ground.
12
ASSEMBLING THE AM LOOP ANTENNA
Insertting the tabs into the base as shown.
CONNECTING THE AM ANTENNA CABLE
Press and hold Insert wire
AM Loop Antenna
16 to 32ft (5 to 10m)
Black White
Vinyl-coated wire
GND GND
AM AM
FM FM
( ( 75 Ω ) )
75Ω
Ground

CONNECTING OF AC POWER CABLE

1.
Plug the supplied AC power cable to the
AC IN socket on the rear panel of the main
unit.
AC IN
Release
2.
Plug the power cable into an AC outlet.
AM External
Antenna

BASIC OPERATION

AMP OPERATION

TURNING ON THE UNIT
1.
Connect the AC power cable to the wall
outlet.
2.
Turn the power on to other units connected
to this unit.
3.
Press the POWER ON/STANDBY button of
this unit. Every time the button is pressed,
the power to this unit toggles between on
and standby.
To activate power using the remote
controller, press the AMP button, followed
by the ON button and SOURCE ON/OFF
button of the remote controller.