Getting Started; Using The Remote Control - Coby DP-5588 Instruction Manual

5.6” widescreen color tft lcd digital photo frame with analog clock
Hide thumbs Also See for DP-5588:
Table of Contents

Advertisement

Using the Remote Control

To load a battery in the remote:
1.
Pull in the direction of the arrow
2.
Slide the compartment out
3.
Place the battery in the compartment with the positive side ( + ) facing up
4.
Push the compartment in to close
To use the remote:
Point the remote at the remote sensor of the photo frame at a distance of no
more than 15' and at an angle no greater than 60 degrees.
Batteries will last for about one year under typical usage. Replace the batter-
ies if the remote is no longer working.
Do not spill water on the remote control.
Do not use the remote control for other equipment at the same time.
Remove the batteries if the remote control will not be in use for an extended
period of time.
The battery used in this device may present a fire or chemical hazard
if mistreated. Do not recharge, disassemble, incinerate, or heat the
batteries.
Used batteries should be disposed of safely and not incinerated. Attention
should be shown to the environment aspects of battery disposal.
Keep batteries out of the reach of children.
Page 1
Page 1

getting started

Coby Electronics Corporation
Coby Electronics Corporation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents