Installation - Primo Water PR109RK Manual

Table of Contents

Advertisement

Available languages

Available languages

WWW.PRIMO-ELEKTRO.BE
Remove all packing material, both inside and outside.
Clean the outside of the unit with a dry cloth. You can clean the inside with a
soft damp cloth.
Do not place the appliance in a narrow passage, direct sunlight or moisture.
Make sure that air can circulate freely around the refrigerator. The back of the
refrigerator should be at least 10 cm away from the wall.
Place the refrigerator on a firm, level surface.
Avoid direct sunlight and heat. Sunlight can damage the outside of the
refrigerator. Heat will cause higher consumption.
Avoid excessive humidity. Too much moisture in the air will cause frost to form
too quickly inside your refrigerator.
You can set the temperature inside the appliance with the thermostat. The
higher the setting (COLDER), the harder the refrigerator will cool.
TEMPERATURE CONTROL
The refrigerator is controlled by a temperature controller located inside the
appliance. Adjust the controller to the desired position.
COLD = 7-10°C
Operating time and operating temperature are affected by where the fridge
is used, the number of times the door is opened and the temperature of the
room the fridge is in.
When you start using the appliance or after defrosting the appliance, set the
controller to the coldest setting for at least 2 hours before inserting food and
then set to the "NORMAL" setting.
STORAGE GUIDE
For the best storage, set up your refrigerating appliance as follows:
Refrigerator compartment
Door rack
Crisper drawer

3. INSTALLATION

NORMAL = 4-7°C
Type of food
Food with natural preservatives such as jams,
juices, drinks, spices, etc.
Do not store food with a limited shelf life here
Fruits, herbs, and vegetables
Do not refrigerate bananas, onions, potatoes,
or garlic
33
PR109RK
COLDER = 0-4°C

Advertisement

Table of Contents
loading

Table of Contents