ZKTeco IWB86BPAQ Installation Manual

Mobile Stand Installation Guide
· To ensure correct and safe use, read
carefully read this manual before installation.
· It is recommended to equip this model with a 55 to 86 inch
interactive whiteboard.
· The maximum weight of the bearing can support up to 100 kg.

Packing list

A - Left support 1 piece
B - Right support 1 piece
Cross recessed hex head screw
Spring cushion M12
M6 screw*
Phillips Screwdriver (User Prepared)
Adjustable Wrench (User Prepared)
Note: "*" Indicates that due to differences in models, some models include this accessory, please refer to the current one.
C - Wall bracket 1 piece E - Wheels 4 pieces
D - Tray 1pc
F - Bar for hanging on the wall 2 pieces*
M8 × 25 mm
14 pieces
ÿ20×ÿ13 mm
4 pieces
M6 × 130 mm
2 pieces
1 PC
1 PC

installation steps

Version: 1.1
Step 1
Set the wheel to the brake state and screw it into the brackets
(as in Figure 1).
Adjust the wheel to
the braking state before
operation.
Figure 1
Step 3

Attach the right bracket to the other end of the bracket

wall (as shown in Figure 3).
1
figure 3
Step 2

Attach Wall Bracket to Left

Bracket (as in Figure 2), 3 sets of
mounting heights (1 & 4, 2 & 5, 3 & 6),
optional on demand.
hole position
1
2support 3
4
5
6

Wall Bracket Hole Suggestions

1
Compatible models Matching holes
55"
3, 6 2, 5 1,
65" - 70"
4
75" - 86"
Front of
Front of
Figure 2
Step 4
Installation of the tray between the two
supports (as in Figure 4).
First insert the
Tray on
locating pin
on the stand
adjust the
Tray in
positioning
pins
fasten all 1
bolts
Figure 4