Advertisement
Table of Contents
G2800L(US)_GU1843 2004.2.6 1:14 PM ページ01
FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA
EMISSION CONTROL WARRANTY are applicable to only those engines/
generators complied with EPA (Environmental Protection Agency) and CARB
(California Air Resources Board) emission regulations in the U.S.A.
To the engines/generators exported to and used in the countries other than the
U.S.A., warranty service shall be performed by the distributor in each country in
accordance with the standard Makita engine/generator warranty policy as applicable.
To show compliance with California emission regulations, a hangtag has been
provided displaying the Air Index level and durability period of this engine.
The Air Index level defines how clean an engine's exhaust is over a period of
time. A bar graph scaled from "0" (most clean) to "10" (least clean) is used to
show an engine's Air Index level. A lower Air Index level represents cleaner
exhaust from an engine.
The period of time (in hours) that the Air Index level is measured is known as
the durability period. Depending on the size of the engine, a selection of time
periods can be used to measure the Air Index level (see below).
Descriptive Term
Moderate
Intermediate
Extended
Notice : This hangtag must remain on this engine or piece of equipment, and
only be removed by the ultimate purchaser before operation.
WARNING :
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects or other reproductive
harm.
NOTICE
NOTICE
AIR INDEX
Applicable to Emissions Durability Period
-
50 hours (engine from 0 to 65 cc)
125 hours (engine greater than 65 cc)
-
125 hours (engine from 0 to 65 cc)
250 hours (engine greater than 65 cc)
-
300 hours (engine from 0 to 65 cc)
500 hours (engine greater than 65 cc)
US
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
Advertisement
Table of Contents
Related Manuals for Makita G4300L
Summary of Contents for Makita G4300L
- Page 1 To the engines/generators exported to and used in the countries other than the U.S.A., warranty service shall be performed by the distributor in each country in accordance with the standard Makita engine/generator warranty policy as applicable. To show compliance with California emission regulations, a hangtag has been provided displaying the Air Index level and durability period of this engine.
- Page 2 EPA regulations during its warranty period. For the components listed under PARTS COVERED, the Makita Factory Service Center or Service Center authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U.S. EPA regulations.
- Page 3 HOW TO MAKE A CLAIM All repair qualifying under this limited warranty must be performed by a Makita Factory Service Center or Service Center authorized by MAKITA . In the event that any emission-related part is found to be defective during the warranty period, you shall notify Makita Warranty Department at 1-800-4- MAKITA and you will be advised of the appropriate warranty service dealer or service providers where the warranty repair can be performed.
- Page 4 -As the engine owner, you should be aware, however, that MAKITA may deny you warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.
- Page 5 REPAIR AND REPLACEMENT OF EMISSION-RELATED PARTS It is recommended that only engine replacement parts which have been authorized and approved by MAKITA should be used in the performance of any warranty maintenance or repairs of emission-related parts. These replacement parts will be provided at no charge if the part is still under warranty.
- Page 6 G2800L(US)_GU1843 2004.2.6 1:14 PM ページ06...
-
Page 7: Table Of Contents
G2800L(US)_GU1843 2004.2.6 1:14 PM ページ1 Thank you very much for purchasing a MAKITA GENERATOR. This manual covers operation and maintenance of the MAKITA GENERATOR. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. -
Page 8: Safety Precautions
The generator has a built-in forced air cooling system, and may become overheated if it is enclosed. If generator has been covered to protect it from the weather during non use, be sure to remove it and keep it well away from the area during generator use. - Page 9 The operator may suffer severe electric shock if the generator is wet due to rain or snow. WARNING If wet, wipe and dry it well before starting. Do not pour water directly over the generator, nor wash it with water.
- Page 10 Rated frequency (Hz) Maximum site altitude above sea-level (m) Fire, open light and smoking prohibited. Caution, risk of electric shock. Do not connect the generator to the commercial power lines. IN-position of a bistable push control Protective earth (ground) Fuse...
-
Page 11: Components
G2800L ..0.6 liters G3200L ..0.6 liters G4300L ..1.0 liters Recommended engine oil: Use 4-stroke automotive detergent oil of API service class SE or higher grade (SG, SH or SJ is recommended). -
Page 12: Operating Procedures
If the pilot lamp is off, Set the AC breaker ■ ■ to "ON" position. If no generating condition is found out, ■ ■ please consult nearest Makita factory or authorized service center. " (RUN) " (CHOKE) CAUTION " (RUN) position. - Page 13 G2800L(US)_GU1843 2004.2.6 1:14 PM ページ7 2. USING ELECTRIC POWER Make sure that the appliance is switched OFF before connecting it to the generator. ■ ■ Do not move the generator while it is running. ■ ■ Be sure to ground the generator if the connected appliance is grounded. Failure to ■...
- Page 14 (d) Turn on the switch of the appliance. 3. STOPPING THE GENERATOR (a) Turn off the power switch of the electric equipment and unplug the cord from receptacle of the generator. (b) Allow the engine about 3 minutes to cool down at no load before stopping.
-
Page 15: Wattage Information
■ ■ to 5 times the normal running wattage in order to start. For example, a 5000 watt generator would only be able to drive a 1000 to 1700 watt pump. NOTE The following wattage chart is general guide only. Refer to your specific appliance for correct wattage. - Page 16 VOLTAGE DROP IN ELECTRIC EXTENSION CORDS When a long electric extension cord is used to connect an appliance or tool to the generator, a certain amount of voltage drop or loss occurs in the extension cord which reduces the effective voltage available for the appliance or tool.
-
Page 17: Spark Arrester
G2800L(US)_GU1843 2004.2.6 1:14 PM ページ11 6. SPARK ARRESTER In a dry or wooded area, it is recommendable to use the prodoct with a spark arrester. Some areas require the use of a spark arrester. Please check your local laws and regulations before operating your prodoct. The spark arrester must be cleaned regularly to keep it functioning as designed. -
Page 18: Maintenance Schedule
(3) Intake manifold, if applicable (4) Air cleaner elements The maintenance schedule indicated in the table is based on the normal generator operation. Should the generator be operated in extremely dusty condition or in heavier loading condition, the maintenance intervals must be shortened depending on the contamination of oil, clogging of filter elements, wear of parts, and so on. - Page 19 Do not pour it down into sewage drains, onto garden soil or into open streams. Your local zoning or environmental regulations will give you more detailed instructions on proper disposal. *Note: 2. As to the procedures for these items, please refer to the SERVICE MANUAL or consult your nearest Makita service dealer. Every Every...
-
Page 20: How-To" Maintenance
Check the brush every 500 hours or if generator performance is irregular. If the brush is 5 mm (0.2 in.) long or less, replace it with a new one. -
Page 21: Preparation For Storage
G2800L(US)_GU1843 2004.2.6 1:14 PM ページ15 9. PREPARATION FOR STORAGE (See Fig. 6 6 ) The following procedures should be followed prior to storage of your generator for periods of 6 months or longer. Drain fuel from fuel tank carefully by disconnecting the fuel line. -
Page 22: Specifications
10.8 (2.9) Recoil 537 (21.1) 432 (17.0) 475 (18.7) 43 (94.8) 48 (105.8) 0.1±0.03 (0.0039±0.0012) Note : Adjust the valve clearance while the engine is cold. 500 hours G4300L EX27 12.8 (3.9) 580 (22.8) 477 (18.8) 508 (20.0) 55 (121.3) -
Page 23: Wiring Diagram
G2800L(US)_GU1843 2004.2.6 1:14 PM ページ17 12.WIRING DIAGRAM G2800L / G3200L (60Hz-120V) GENERATOR Wiring color cord : Black LBlu : Light blue Blk/W : Black/White : Brown : Blue Brn/W : Brown/White CONTROL PANEL AC circuit breaker receptacle (120V) Pilot lamp... - Page 24 G2800L(US)_GU1843 2004.2.6 1:14 PM ページ18 G4300L (60Hz-120V) GENERATOR CONTROL PANEL Wiring color cord : Black LBlu : Light blue Blk/W : Black/White : Brown : Blue Brn/W : Brown/White AC circuit breaker receptacle receptacle (120V) (120V) Pilot lamp Grn/Y Earth...