Speed Change; Operation - Makita BTW200 Instruction Manual

A
B
1. Speed change lever
ASSEMBLY
1
3
2
4
1. Socket
2. Anvil
3. Hole
4. Detent pin

OPERATION

12

Speed change

002330
To change the speed, first switch off the tool and then slide
the speed change lever to the "A" side (2) for high speed or
"B" side (1) for low speed. Be sure that the speed change
lever is set to the correct position before operation. Use the
right speed for your job.
1
CAUTION:
• Always set the speed change lever fully to the correct
position. If you operate the tool with the speed change
lever positioned halfway between the "A" side (2) and "B"
side (1), the tool may be damaged.
• Do not use the speed change lever while the tool is
running. The tool may be damaged.
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and inconsistent
fastening torque and/or damage to the bolt or nut.
Installing or removing socket
002343
To install the socket, align the hole in the side of the socket
with the detent pin on the anvil.
Push the socket onto the anvil until it snaps into place. Tap it
lightly if required.
To remove the socket, depress the detent pin through the
hole in the socket and pull the socket off the anvil.
CAUTION:
• Always insert the battery cartridge all the way until it
locks in place. If you can see the red part on the upper
side of the button, it is not locked completely. Insert it
fully until the red part cannot be seen. If not, it may