Makita AN451 Instruction Manual page 4

There may be local regulations concerning noise
which must be complied with by keeping noise levels
within prescribed limits. In certain cases, shutters
should be used t o contain noise.
Do
not tamper with the tool or attempt t o use
it
for
other than nailing.
Do
not play with the contact
element; it prevents accidental discharge, so it must
be kept on and not removed. Securing the trigger
in the ON position is also very dangerous. Never
attempt t o fasten the trigger.
Operate the tool within the specified air pressure of
4.5
-
8.5 kgflcm'G (65
-
120 PSIG) for safety
and longer tool life.
Do
not exceed the recommend-
ed max. operating pressure of 8.5 kgf/cm'G (120
PSIG). The tool should not be connected to a source
whose pressure potentially exceeds 14.0 kgf Icm'G
(200 PSIG).
Never use the tool with other than compressed air.
If high-pressure gas (carbon dioxide, oxygen, nitro-
gen, hydrogen, propane, acetylene, etc.) is used as
a power source for this tool, the tool will explode
and cause serious injury.
-Trigger
element
120 PSIG 120 PSIG
/
/
q r j
COMPRESSED