Contents Introduction................................ 3 Charging Base Overview ........................... 4 Requirement..............................4 Overview............................... 4 Charging Base Installation ..........................5 Installing the Terminal Charging Base......................5 Installing the Terminal Silicone Sleeve ......................6 Using the Charging Base ........................... 7 Using the Charging Base ..........................7 LED Status Light ............................
Installation Guide Charging Base This document explains how to install the charging base for the PAX A920 or A920 Pro terminal and included silicone sleeve. The charging base makes it easy to recharge the terminal without having to remove the silicone sleeve to ensure that the USB power connector is properly seated in the terminal’s charging port.
To ensure the best charging results, you must use the original AC power adapter that came with your PAX A920 or A920 Pro terminal. The AC power adapter should have the PAX logo printed on one side as shown below:...
PAX A920 / A920 Pro Installation Guide Charging Base Before you install and connect the charging base, make sure that the desired location is within reach of an AC outlet and that there is enough space to for the charging base and the terminal when connected.
Plug the adapter into an AC outlet. The LED at the bottom edge of the base lights up. To protect your PAX A920 or A920 Pro terminal from minor impact damage, you should install the silicone sleeve provided with the terminal charging base as the charging base is designed specifically for terminals with the sleeve.
PAX A920 / A920 Pro Installation Guide Charging Base To use the charging base, you need only place the terminal(s) vertically on the base so the printer rests in the cradle at the top of the charging base. NOTE: The charging base should only be used to charge your terminal(s);...