Mitsubishi Electric 2033G Series Owner Technical Manual page 25

MITSUBISHI
ELECTRIC
Battery check screen
This feature permits you to perform a battery check. Pressing the Test button causes battery
check to be run for roughly 20 seconds. Check system mimic diagram on the MAIN MENU
Screen or Battery log screen to make sure that the feature works properly.
Remote/Local screen
This feature enables you to set the UPS module for remote operation or direct (local) operation.
On pressing MAIN Touch icon at the top, the display returns to the MAIN MENU Screen or goes
to the History (log) screen or Setup screen.
2) UPS failure [ALARM] (Red)
Illuminated when UPS is in fault mode.
3) Battery operation [BAT OP.] (Orange)
Illuminated when the battery is operating following an AC power failure.
4) Load on inverter [INV OP.] (Green)
Illuminated when power is supplied from inverter to the critical load.
5) Load on bypass [BYP OP.] (Orange)
Illuminated when power is supplied to load devices by bypass line.
6) Inverter start [START] (Green)
Inverter start button.
When pressed, the load will transfer from the bypass line to the inverter.
7) Inverter stop [STOP] (Orange)
Inverter stop button. When pressed, the inverter can be stopped.
The load will transfer from the inverter to the bypass line.
8) Emergency Power Off [EPO] (Red)
Shuts down UPS when pressed. Load is dropped.
MITSUBISHI ELECTRIC 2033G SERIES UPS
2033G SERIES UPS
OWNERS / TECHNICAL MANUAL
Page Number:
2-5