Advertisement
ETC Installation Guide
P-NSPS-D
combination of bus, star, loop, or home-run. The total combined length of a
LinkConnect wire run using Belden 8471 may not exceed 500 m (1,640 ft),
with a maximum distance of 400 m (1,312 ft) between any two devices.
Note:
qualified installer and follow standard wiring installation practices.
Ethernet
Use a Category 5e or better Ethernet cable with an RJ45 connector to connect
the Network Station Power Supply to the Paradigm lighting control network.
Compliance
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. Any modifications or changes to this product not
expressly approved by Electronic Theatre Controls, Inc. could void the user's
authority to operate the product. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user will be
required to correct the interference at their own expense.
P-NSPS-D
All control wiring should be installed and terminated by a
Page 3 of 8
ETC
Advertisement
