Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Odor has formed in
the appliance
Pine tree.
The display is off and
flashing.
"E:30 / -80"
"E:36 / -25 / -26"
44
Cause and Troubleshooting
Humidity and detergent residue can encourage
bacterial growth.
→ "Cleaning the drum", page 39
▶
▶ When you are not using the appliance, leave the door and
detergent drawer open to allow the residual water to dry
out.
The energy saving mode is active.
Press any button. aThe display
▶
lights up again.
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
Drain pump is clogged.
→
"Cleaning the drain pump", page 40
▶
Water drain hose is connected too high.
Install the water drain hose at a maximum height of 1
▶
meter.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Unauthorized extension mounted on the water drain
hose.
Remove any unauthorized extensions from the
▶
water drain hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The pump cover handle
must be vertical.
→
"Cleaning the drain pump", page 42
Drain pump is clogged.
→
"Cleaning the drain pump", page 40
▶
Advertisement
Table of Contents
