Transporting, Storing And Drain; Preparing The Device For Transport; Disposal Of Your Old Appliance - Bosch WTH83002FG User Manual And Installation Instructions

Clothes dryer
Table of Contents

Advertisement

NLTransport, storage and disposal
17 Transport, on-
hit and drain
17.1 Preparing the device for
transport
PAY ATTENTION!
If the device is used immediately after
transport, the refrigerant in the
device may cause damage to the
device.
Let the device rest for two hours
immediately after transport before
using it for the first time.
Tip:The device may contain residual
water and drip during transport.
Transport the device upright.
Requirements
sThe condensed water container is
emptied. Empty the condensation
container → Page 30
sThe device is turned on.
→ "Switch on device", page
25
Set any program.
1.
Start the program
2.
→ Page 26 and wait 5 minutes.
aThe condensation water has been pumped out.
Turn off the device.
3.
→ "Switch off the device",
page 26
Remove the water drain hose from
4.
the connection point.
Secure the water drain hose on the
5.
device against unintentional
loosening.
Make sure that the water
drain hose is not kinked.
Emptying the condensed water container
6.
→ Page 30 .
42
Push in the condensed water
7.
container → Page 30 .
Disconnect the plug of the device
8.
from the mains.
aThe device is ready for trans-
port wine.
17.2 Disposal of your old
appliance
Environmentally friendly disposal
allows valuable raw materials to be
reused.
WARNING
Risk of health hazard!
Children can lock themselves in the
appliance and endanger their lives.
Do not install the appliance behind
a door that blocks or prevents the
opening of the appliance door.
In the case of discarded appliances,
remove the plug of the mains cable
from the socket, then cut the mains
cable and damage the lock of the
appliance door so that the appliance
door no longer closes.
WARNING
Risk of fire!
The refrigerant R290 in this device is
environmentally friendly but
flammable and can catch fire if not
properly disposed of.
Dispose of the device properly.
Make sure that the pipes of the
cooling circuit are not damaged.
Unplug the power cord from the
1.
outlet.
Cut the power cord.
2.
Dispose of the device in an environmentally friendly way.
3.

Advertisement

Table of Contents
loading

Table of Contents