Table of Contents
Advertisement
en Installation and connection
Installation loca-
tion
In a washer-dryer
stack
Against a wall
4.4 Water drain hose
Condensation forms during drying,
which your appliance uses for auto-
matic cleaning. Use the water drain
14
Requirements
Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
¡ Connection kit
with pull-out
worktop
→ Page 29
¡ Connection kit
→ Page 29
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
Do not trap the
hoses and power
cord between the
wall and the ap-
pliance.
hose to drain away excess condens-
ation directly into the waste water
system.
Notes
¡ Operate this appliance using the
water drain hose provided. If you
connect the water drain hose
→ Page 14, you do not have to
regularly empty the condensation
container → Page 34.
¡ You can order this optional
→ "Accessories", Page 29 from
our customer service.
Connecting the water drain hose
If you do not want to regularly empty
the appliance's condensation con-
tainer, connect the water outlet hose.
ATTENTION!
When operating the appliance
without the water drain hose being
connected properly, liquid may leak
out of the connecting piece.
Before operating the appliance,
▶
connect the water drain hose prop-
erly to the connecting piece.
Requirements
¡ The appliance and the accessory
have been unpacked.
→ "Unpacking the appliance",
Page 12
¡ The appliance is installed at the in-
stallation location.
→ "Requirements for the installa-
tion location", Page 13
Advertisement
Table of Contents
