78K0R - Cool it!
3.2 RESET button, SW3
SW3 is the reset button. It activates the power on reset. Switch SW3 controls the reset input signal of the
78K0R/KG3 microcontroller.
3.3 Navigation switch, SW1
Button SW1 is a navigation switch connected to the key interrupt input of the 78K0R/KG3 device. It
operates in five directions including a center push function. The connection of SW1 is shown in the table
below:
3.4 LED1
LED1 is connected to I/O pin P145 / TI07 / TO07 of the 78K0R/KG3 microcontroller. A low signal output
at this I/O pin switches the LED on.
3.5 LED2
LED2 is connected to I/O pin P46 / INTP1 / TI05 / TO05 of the 78K0R/KG3 microcontroller. A low signal
output at this I/O pin switches the LED on.
3.6 Power LED, LED3
LED3 is the power LED of the 78K0R – Cool it! board. It indicates if power is applied to the 78K0R – Cool
it! board.
Table 8: Navigation switch SW1
User's Manual U18426EE1V0UM00
SW1
Connection to the
78K0R/KG3 device
Left
P72/KR2
Down
P74/KR4
Select
P71/KR1
Right
P73/KR3
Up
P70/KR0
16