Advertisement
When cutting thin sheet metals such as
corrugated metal, always cut them at a
position more than 20 mm (25/32") away
from the edge. If you cut them at a position
closer to the edge, a piece cut off could be
sucked into the dust box, causing a severe
injury.
More than
I
20 mm (25132')
CAUTIO N :
Never use
a
deformed or cracked blade. Always replace
it
with a new one.
When the battery charge runs low, the blade easily becomes stuck, and the blade tips
Do not stack materials when cutting them.
Do not cut hardened steel.
Do not touch the saw blade, workpiece or cutting chips with your bare hand immediately
after cutting; they may be extremely hot and could burn your skin.
Do not connect the saw to a vacuum cleaner when cutting metals.
can break. Always recharge the battery cartridge when the blade rpm slows down.
18
Advertisement
