Functional Description; Adjusting The Depth Of Cut - Makita 4112H Instruction Manual

FUNCTIONAL
DESCRIPTION
1
3
2
1. Wing bolt
2. Base
3. Cutting depth
2
1. Clamping nut
2. Wheel guard
A
1
B
2
1. Switch trigger
2. Lock lever
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.

Adjusting the depth of cut

004013
Loosen the wing bolt on the depth guide and move the base
up or down. At the desired depth of cut, secure the base by
tightening the wing bolt.
Only case you adjust the cutting depth to the maximum one,
always be sure to do the adjustment after adjustment of the
wheel guard.
Securing wheel guard
004014
1
CAUTION:
• The wheel guard must be adjusted on the tool so that
the closed side of the guard always points toward the
operator.
The wheel guard can be adjusted about 80 degrees, after
you loosen the clamping nut. Adjust to the desired angle,
then secure the clamping nut.
Switch action
004015
CAUTION:
• Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the "OFF"
position when released.
• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply caution
when locking tool in "ON" position and maintain firm
grasp on tool.
To start the tool, simply pull the switch trigger.(A direction)
Release the switch trigger to stop.
For continuous operation, pull the switch trigger (A direction)
and then push in the lock lever.(B direction)
To stop the tool from the locked position, pull the switch trig-
ger (A direction) fully, then release it.
7