Whats Included; Start Up Procedure - Agil Elektronik eFuse 4 -100-100 Instruction Manual

eFuse 4 -100-100
Attention: The use of the unit shall only be done by trained
personnel.
Attention: Do not use the unit in an explosive environment!
Attention: please do not forget to use the four plastic covers
after connecting screw terminals
Attention: after connecting the litz- wires at the Screw terminals
on rear side, please cover the screws with the plastic covers!
2.2.

Whats Included

efuse 4-100-100
Mains plug connector
Instruction manual for efuse 4-100-100
4 x plastic cover for Screw Terminals on rear side

3. Start Up Procedure

Connect the mains supply cable with the mains Input connector (7 in figure
6.1) at rear of efuse 4.
Attention: The device should only be operated with Mains
Voltage as indicated on the label!
After connecting the mains supply to efuse 4, the unit will do a short check
of the installed Fan. This is done by switching on the fan for about 5
seconds. After done this the unit is ready for use.
The red LED "Off" should be lit. This shows that efuse 4 is in a non
conducting state.
The input voltage is not looped directly through to the Output jacks "OUT"
and "-OUT" (4 in figure 6.1).
manual efuse4-100-100_2022_03_07
18
Ausgabe 31.05.2022