Hose Assembly; Led Lighted Nozzle - RIDGID RV2400HF Assembly

SP6957 ASH RIDGID.qxp_SP6957 5/21/15 3:57 PM Page 9
Vac Assembly (continued)

Hose Assembly

1. Slide the round end of the extension
nozzle into the smaller tapered end of
the wand nozzle.
2. Loosen the two LED assembly screws,
located at the bottom of the LED
Lighted Nozzle.
3. Slide the wand nozzle through the
LED assembly and into the rubber
hose fitting.
4. Retighten the two LED assembly
screws to secure the LED assembly to
the hose assembly.

LED Lighted Nozzle

1. Press button to active LED light while
vacuuming.
2. Slide switch forward to lock the LED
light in the ON position.
3. Slide switch back to the OFF position
after use.
4. To access batteries, remove battery
access panel screw, then remove the
four screws from the LED assembly,
releasing the switch button module.
The two batteries are located under
the switch button module. Dispose of
batteries in the proper waste disposal
container.
5. The LED light uses two CR2016
lithium batteries that are replaceable.
WARNING:
• Keep batteries out of reach of
small children. Consult a
physician immediately if a battery
is swallowed severe burning or
injury may occur.
• Battery contains Perchlorate
Material - Special handling may
apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
Wand
Nozzle
LED Lighted
Nozzle
Switch
Button
Module
CR2016
Lithium
Batteries (2)
9
Extension
Nozzle
Screws (2)
Wand Nozzle
LED Button
LED
Assembly
Screw (1)
Battery
Access
Panel
Screws (4)
LED
Assembly