Advertisement
figuration: The meter bridge
incorporating 32 LED meters
and 2 VU meters shall be a
Mackie MB•32.
The meter bridge incorpo-
rating 24 LED meters and 2
VU meters shall be a Mackie
MB•24. The meter bridge
incorporating 16 LED meters
and 2 VU meters shall be a
Mackie MB•16. The meter
bridge incorporating 24 LED
meters and no VU meters
shall be a Mackie MB•E.
CONSOLE STAND
1. GENERAL CONFIGURA-
TION. The Mackie 8•Bus
Console Stand shall be
provided as a user-as-
sembled kit, consisting of a
left and a right Stand Leg, a
Horizontal Stand Panel and
associated hardware and
instructions. The Stand Legs
and Panel shall be formed
of painted steel, and a kit
shall be available to fit each
of the four 8•Bus Console
configuration sizes. The
Console Stand shall se-
curely support an appropri-
ately configured Mackie
8•Bus Console at a nominal
MACKIE DESIGNS INC. • 16220 WOOD-RED RD. N.E.
WOODINVILLE • WA • USA • PHONE TOLLFREE 800/258-6883
FAX 425/487-4337 • OUTSIDE THE U.S., PHONE 425/487-4333
1005 3/95
29 inches above the floor.
2. STAND LEGS. The left
and right Stand Legs shall
be common in design for
all four configuration sizes.
Each Leg shall have an
angled riser panel, 12" wide
and approximately 26.8"
high, with a mounting
flange at the top and a
weighted foot at the
bottom. The weighted foot
shall be 22.5" in length and
shall extend toward the
front of the Console for
proper balance. The under-
side of each foot shall be
fitted with two steel glides,
adjustable in height to
compensate for uneven
floors. The mounting flange
on the top of each Stand
Leg shall be pre-drilled and
designed to mate with the
existing mounting holes on
the 8•Bus Console series.
Additionally, the Stand Legs
shall have tapped screw
holes provided to mount
the Horizontal Stand Panel.
3. HORIZONTAL STAND
PANEL. The Horizontal
Stand Panel shall be
designed and formed to
provide a stable cross-link
between the two Stand
Legs. The Panel shall be
pre-drilled to mate with the
existing mounting holes on
the Stand Legs. The Hori-
zontal Stand Panels shall be
made in three lengths.
4. INSTRUCTIONS. The
Console Stand shall include
complete, illustrated and
user-friendly assembly
instructions, which shall
conform to existing Mackie
standards for technical
literature without being
actually misleading.
5. DESIGNATION. The
Console Stands shall be
designated according to
Horizontal Panel size: The
Stand incorporating the
40.3" long Horizontal
Panel shall be a Mackie
32STD, and shall mate
with a Mackie 32•8 con-
sole. The Stand incorporat-
ing the 31.5" long Hori-
zontal Panel shall be a
Mackie 24STD, and shall
mate with a Mackie 24•8
console. The Stand incor-
porating the 23.7" long
Horizontal Panel shall be a
Mackie 16STD, and shall
mate either a Mackie 16•8
or a 24•E console.
®
Because Mackie Designs constantly endeavors
to improve its products with new components
and manufacturing methods, all specifications
are subject to change without notice. Rev 1.1
©1995-1998 Mackie Designs.
"Mackie." is a registered trademark of Mackie
Designs Inc.
Advertisement
