Advertisement
Installation and connection
Simply connect the power supply provided and match the WiFi to your home router, connection to the Pen-
tair' s App server is automatic.
By following the instructions, after creating your Pentair account within the Pentair Home App, you will be able
to connect to your installation in a few minutes. The controls sent via the App are effective in a few seconds.
Place the Gateway indoors in a dry and well-ventilated area, far away from any heat sources.
After optimizing the radio range, the Gaetway shouldn't be near, or in contact with metal (parts/objects).
1
2
3
LED meaning
Depending on the lighting frequency of the LEDs, the Gateway provides information on its status.
GATEWAY
Micro cut-off = connected to the server
1 short flash blinking = sending information to the server
1 - Connect one end of the USB cable provided to the µUSB port of the
Gateway.
BE CAREFUL, DO NOT FORCE THE CONNECTION TO THE SOCKET AND
THE CONNECTOR, SEE BELOW THE ORIENTATION OF THE CONNECTOR
2 - Connect the end of the USB cable to the USB port in the power supply.
DO NOT USE ANY POWER SUPPLY OTHER THAN THE ONE PROVIDED.
3 - Connect the power supply to a 230V socket, in compliance with local
applicable standards.
Button
The device is new and free of any provisioning with a home router.
- Proceed as described next pages.
Double flashes :
= new device, no connection
The Gateway is functioning perfectly
5
Advertisement
