Installation Of Drain Hose; Levelling The Washing Machine - Midea MA500W21/W User Manual

INSTALLATION

Installation of drain hose

1.Completely sleeve the drain hose over the sewer.
2.Fix and tighten it with a hoop.( As shown in the figure )
Note!
• Note: The drain hose of the machine with upper drain system has already been
assembled before leaving the factory. This picture is suitable for lower drain system.
Warning!
• Do not kink or protract the drain hose.
• Position drain hose properly ,otherwise damage might result of water leakage.
• If drain hose is too long, do not force it into washing machine as it will cause
abnormal noises.
There are two ways to place the end of drain hose:

Levelling the washing machine

Warning!
• The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached
1.
the cabinet. If not, please turn them to
their original positions tighten the nuts.
Check alignment of the product with a
2.
spirit level and if required, correct.
3.Loosen the lock nut and turn the feet
until it closely contacts with
4.After being locked properly, press four
corners again to make sure that they has
been adjusted properly.
Trough
Hose
Retainer
to
Lock nut
Loosen
the floor.
Raise
9 10
Foot
Right
Lock
Wrong
Lower