Installation Of Drain Hose; Levelling The Washing Machine - Midea 360111 User Manual

INSTALLATION

Installation of drain hose

1.Completely sleeve the drain hose over the sewer.
2.Fix and tighten it with a hoop.( As shown in the figure )
Note!
• Note: The drain hose of the machine with upper drain system has already been
assembled before leaving the factory. This picture is suitable for lower drain system.
！ Warning!
• Do not kink or protract the drain hose.
• Position drain hose properly ,otherwise damage might result of water leakage.
• If drain hose is too long, do not force it into washing machine as it will cause
abnormal noises.
There are two ways to place the end of drain hose:
1.For lower drain system
Under3m
2.For upper drain system

Levelling the washing machine

！ Warning!
• The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to
1.
the cabinet. If not, please turn them to
their original positions tighten the nuts.
Check alignment of the product with a
2.
spirit level and if required, correct.
3.Loosen the lock nut and turn the feet
until it closely contacts with the floor.
4.After being locked properly, press four
corners again to make sure that they has
been adjusted properly.
Under 15cm
Trough Hose
Retainer
Lock nut
loosen
Raise
9 10
water trough
foot
right
lock
wrong
Lower