Timer Number Setting; Setting The Operation Code - Daikin INVERTER FTXM-V Series Engineering Data

FTXM-V Series
3.
Select the desired timer number by
pressing the "TIMER NO." button.
Once the desired timer number is
displayed,
button.
The display for timer number 2
will stop blinking.
The " " display will disappear
No.
after 3 seconds.
Select " " in the timer number when you do not
wish to set a timer number.
It is possible to set only one timer number.
(The times for turning the unit(s) on and off twice a
day can be set with a single timer number.)

• Timer Number Setting

Group control: select the unit in the individual
Batch control: set the timer numbers for all con-
Zone control: set the timer numbers for all
• Since the timer number will be set to after-
press priority, the timer number in the last
screen set will be valid for the connected
units.
Example 1
Setting timer number 1 for unit 1-00 to "1" and
timer number 2 to "2" in the individual screen and
then setting timer number 1 to "3" and timer
number 2 to "4" in the batch screen causes the
timer numbers for all units to be set, so timer
number 1 for unit 1-00 will be "3" and timer num-
ber 2 will be "4".
Example 2
To prevent leaving units on, timer number 1 is
set to "5" in the batch screen.
Setting timer number 1 in zone number 1 to "
in the zone screen after that will change the
timer number for zone number 1, so the setting
to prevent leaving the units on will be lost for
zone number 1 only.
If a timer number is set incorrectly by accident,
redo the setting in the desired screen.
• What happens when the timer number on
time and off time are set to the same time
When the on time and off time are set to the
same time for the same timer number, operation
does not change.
When the on time and off time are set to the
same time for different timer numbers, the off
time is given priority.
press the "SET"
screen and set the timer number.
nected units.
zone-registered units.
Call up the zones which you wish
to set in the zone screen and set
the timer numbers.
When using timer operation, make sure the
times do not overlap when setting the program of
the schedule timer.
Setting the Operation Code (Fig. 11)
[Registration]
1.
Pressing the "CONTROL MODE"
button causes the currently set operation
code to blink.
Call up the desired code number by pressing the
"CONTROL MODE" button.
Scroll through the code numbers.
2.
Once the code number is displayed,
press the "SET" button.
The display will stop blinking.
The operation code display will disappear after
3 seconds.
[The Operation Code Setting]
Group control: select the unit in the individual screen
and set the operation code.
Batch control: set the operation code for all con-
nected units.
Zone control: set the operation code for all zone-reg-
istered units.
Call up the zones which you wish to set
in the zone screen and set the opera-
tion code.
Since the operation code will be set for after-press pri-
ority, setting the operation code in the zone and individ-
ual screens after setting the operation code in the
batch screen, will cause the operation codes set after-
wards to be valid.
"
162
EDUS042101
12
3P124623-1E