Panasonic SDR-S100E Service Manual page 37

Service Manual
Diagrams and Replacement
Parts List
SD Video Camera
SDR-S100PP
SDR-S100E
SDR-S100EB
SDR-S100EG
SDR-S100GC
SDR-S100GK
Vol. 1
Colour
(S)...........Silver Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Monitor P.C.B. ...................................................................... S-2
S2.2. Mic P.C.B. ............................................................................ S-2
S2.3. Front P.C.B. .......................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Monitor Schematic Diagram .................................................. S-5
S4.3. Mic-IR Schematic Diagram ................................................... S-6
S4.4. Front Schematic Diagram ..................................................... S-7
S4.5. CCD-FPC Schematic Diagram.............................................. S-8
VM0509041CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as " " mark.
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S5. Print Circuit Board .................................................................. S-10
S5.1. Monitor P.C.B. .................................................................... S-10
S5.2. Mic P.C.B. ........................................................................... S-14
S5.3. Front P.C.B. ....................................................................... S-15
S5.4. CCD Flex Card P.C.B. ........................................................ S-16
S5.5. CCD Card P.C.B.(R) ............................................................ S-17
S5.6. CCD Card P.C.B.(G) ........................................................... S-17
S5.7. CCD Card P.C.B.(B) ............................................................ S-17
S6. Replacement Parts List .......................................................... S-19
S7. Exploded Views ...................................................................... S-24
S7.1. Frame and Casing Section.................................................. S-24
S7.2. LCD Section ........................................................................ S-25
S7.3. Lens Section ....................................................................... S-26
S7.4. Packing Parts and Accessories Section .............................. S-27
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram
Name of Signal
S-1
HAVE THE SPECIAL CHARACTERISTICS