Table of Contents
Advertisement
The parts that have been removed must not be washed. Clean
the panels with a glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Refitting
Place the cover back in position (Fig. A).
1.
First retighten the two screws at the bottom, then the two
2.
screws at the top (Fig. B).
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If your meal is not successful, please refer to section . We have
tested the recipe for you in our cooking studio. Here, you will
find useful cooking tips and tricks for cooking, baking and
roasting.
:
Risk of electric shock!
Repairs that are not carried out properly are dangerous.
Repairs must only be performed by one of our after-sales
service technicians.
Malfunction
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut.
Oven not hot.
Dust on the
contacts.
The burner
Power has
does not ignite.
failed or igni-
tion plugs are
damp.
Look in the fuse box to see
if the circuit breaker is
defective.
Check whether the kitchen
light and other kitchen
appliances are working.
Turn the control knobs sev-
eral times to the left and
right.
Light the gas burner with a
gas lighter or a match.
Fitting the oven door See the section Fitting the oven door.
3.
Do not use the oven again until the panels have been
correctly fitted.
Oven door - Additional safety precautions
During long cooking times, the oven door may become very
hot.
If you have small children, extra supervision is required during
oven operation.
In addition, there is a protective device (protective grid) which
prevents direct contact with the oven door. You can purchase
this optional accessory (469088) from the after-sales service.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
19
Advertisement
Table of Contents
