Dimplex DCEVP6WT Instruction Manual page 9

Functions
Note: The buzzer beeps twice when the power supply is first turned on. The unit
is in 'standby' until the On/Off button is pressed.
The horizontal louvres need to be opened manually by hand.
ON/OFF
Press the ON/OFF button to turn the unit ON. The default settings when first turned
on are low fan speed, normal wind mode, and no timer. When turning the unit back
on after powering it off, the state upon turning it off will be memorised, excluding
the timer setting. If the sleep wind mode was on before turning off, the mode will
not be memorized after turning it on again, but the normal wind mode will start. To
turn the unit OFF press this button again. It may take a few seconds to power off
completely.
WIND SPEED
Press the Wind speed key to adjust the wind speed on the device. The device has
3 wind speed settings being low, medium and high. After high speed, pressing the
button again will bring the appliance back to low speed. For the drying function,
press the Wind Speed key for 3 seconds.This will cause the unit to enter high wind
speed for 20 minutes. After this 20 minutes, the device will automatically shut down
and enter standby mode.
SWING
Press the Swing key to turn the swing function on or off. The device will swing left to
right when this function is switched on.
TIMER
The TIMER can be set in 1 hour increments up to the maximum timer of 24 hours.
The set time will be indicated on the display panel before switching back to the wind
speed. Press the Timer Function button to set your desired time.
COOLER / HUMIDIFIER
Press this button once to turn on the COOLER / HUMIDIFIER function, the pump will
start and the COOLER / HUMIDIFIER LED will illuminate. Press this button again to
turn off the cooling function, and to use as a fan only.
9