Vga Connector P100 - HP M27fw Maintenance And Service Manual

This procedure includes VGA, HDMI connectors.
The connectors are on the main board.
The connectors identifiers are as follows:
Connector
VGA
HDMI
Before repairing connectors, follow these steps:
▲
Prepare the monitor for disassembly. See Preparation for disassembly on page 9.
VGA P100
Repair the VGA connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You can gently
push down with the soldering iron once everything is molten to move the P100 out of the through holes.
2) Lift the P100 connector from the PCB..
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
Location
P100
P200/P201
P201
P200 P100
13