Intended Use; Additional Safety Rules - Panasonic EYFLB1A Operating Instructions Manual

I

. INTENDED USE

This tool is a Cordless Impact Driver/Wrench
and can be used to tighten bolts, nuts, and
screws.
Read "the Safety Instructions" booklet
and the following before using.
II
. ADDITIONAL SAFETY
RULES
1) Wear ear protectors when using the
tool for extended periods.
) Be aware that this tool is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
3) When screwing or driving into walls, floors,
etc., "live" electrical wires may be encoun-
tered. DO NOT TOUCH THE HEX QUICK
CHUCK OR ANY FRONT METAL PARTS
OF THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock in
case you screw or drive into a "live" wire.
4) Do NOT operate the Forward/Reverse
lever when the main switch is on. The bat-
tery will discharge rapidly and damage to
the unit may occur.
5) During charging, the charger may become
slightly warm. This is normal.
Do NOT charge the battery for a long period.
6) When storing or carrying the tool, set the
Forward/Reverse lever to the center posi-
tion (switch lock).
7) Do not strain the tool by holding the speed
control trigger halfway (speed control
mode) so that the motor stops.
Symbol
V
n
0
... min
-1
Ah
III
ASSEMBLY
.
Attaching or Removing Bit
NOTE:
• When attaching or removing a bit, dis-
connect battery pack from tool or place
the Forward/Reverse lever in the center
position (switch lock).
1. Hold the collar of quick connect chuck and
pull it out from the tool.
. Insert the bit into the chuck. Release the
collar.
3. The collar will return to its original position
when it is released.
4. Pull the bit to make sure it does not come out.
5. To remove the bit, pull out the collar in the
same way.
CAUTION:
• If the collar does not return to its original
position or the bit comes out when pulled
on, the bit has not been properly attached.
Make sure the bit is properly attached
before use.
EYFLB1A/EYFLB2A/EYFLB3A
1 mm
(15/3")
- 17 -
Meaning
Volts
Direct current
No load speed
Revolutions or reciprocations
per minutes
Electrical capacity of battery
pack
Read the operating
instructions before use.
For indoor use only.
9 mm – 9.5 mm 6.35 mm
(3/64" – 3/8") (1/4")