HDBaseT 70m HDMI HDBaseT2.0 - Extender Manual

1. Please pay attention to all the warnings and hints on this device.
2. Do not expose this unit to rain, moisture and liquid.
3. Do not put any stuff into the device.
4. Do not repair or open this device without professional people's guidance.
5. Shut off power and make sure environment is safe before installation.
6. Do not plug-in/out the connected cables when it is in using.
7. Make sure the specification matched if using 3 party DC adapters.

This HDBaseT2.0 single network cable extender transmits HDMI signal up to 70meters over cat6 fluently and clearly. It is lossless in signal and supports 3D, 24bits deep color, CEC, HDCP and ultra HD 4KX2K@60Hz.

It's a perfect solution for audio&video transmission in applications of HD conference system, HD multimedia education system, HD digital advertising and signage etc.

Features

Package Contents

Installation Requirements

Panel Description

1. TX Sender
   

Installation Procedures

1. To make a Cat6/6A/7 network cable
   Follow the standard of IEEE-568B:

2. Connections

4. RS232 serial bi-direction passback function
   1. Baud rate
      Different encoding mechanism can not mix-connect, the baud rate of RS232 serial of these transmitter unit and receiver unit, support 2400, 4800, 9600, 19200, 28800, 38400, 57600, and 115200
   2. Line order
      Check and make sure the RS232 serial line connect firmly and well, and make sure serial data line is connected correctly as below: If the RS232 serial does not work by following above connection,

3. Check baud rate
   If need to check the baud rate at last time, firstly, set the baud rate to 115200 on your serial port test tool before power on. Then power on, when the RS232 serial of product connects to serial port test tool, the software will read out the baud rate at once.
   e.g: software show information " Baud rate: 9600", means 9600 is the current baud rate.
4. Set baud rate
   For example: the current baud rate is 9600, but the baud rate of control equipment is 19200, so the baud rate should be set as 9600/ At this time, in serial port tool, choose baud rate "9600", then input command "set: 19200" in character format and send it out.

FAQ

Q: No output on screen?

A:

1. Firstly, please check and make sure the power supply is connected well. Then, check and make sure all cables are connected correctly.
2. Please check and make sure the right HDMI input port of the TV/ screen has been chosen.
3. Please check and make sure there is HDMI signal to be fed into transmitter unit, and check and make sure the receiver unit has been connected well with the display device.

Q: Indicator LED 2 keeps off and no output?

A: Check and make sure the HDMI display device has been switched to the right HDMI input channel.

Q: Indicator LED 3 keeps off?

A: Check whether the TX's HDMI IN has signal input and make sure RX's OUT is well connected with HDMI display.

Q: Output image with snow point?

A: Change the HDMI cable between the transmitter unit and the source device, it will be better to use a shorter HDMI cable for re-testing.

Specification

Disclaimer

The product name and brand name may be registered trademark of related manufactures. ™ and ® may be omitted on the user manual. The pictures in this user manual are just for reference. The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. We reserve the rights to make changes without further notice to a product or system described herein to improve reliability, function or design.