Advertisement
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by SANGEAN ELECTRONICS INC. is under license.
For United States:
Cautions to the user
The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
RF exposure statements
To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user's authority to operate the device.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaranty that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to so.
Pairing and playing your Bluetooth device for the first time
Disconnecting your Bluetooth device
Rotate the Mode knob to select any mode other than Bluetooth mode to disconnect with your Bluetooth device or turn off Bluetooth function on your Bluetooth device to disable the connection.
Using Battery | |
FM Band Output Power: | 1.4W T.H.D 10% @ 110Hz |
Bluetooth Output Power: | 1.7W T.H.D 10% @ 110Hz |
AUX Input sensitivity: | IN 360mV Output 1.7W @110Hz |
Using AC power adaptor | |
FM Band Output Power: | 3.6W T.H.D 10% @ 110Hz |
Bluetooth Output Power: | 4W T.H.D 10% @ 110Hz |
AUX Input sensitivity: | IN 360mV Output 4W @110Hz |
Bluetooth | |
Bluetooth specification | Bluetooth ® Ver 4.1 |
Profile Support | A2DP |
Bluetooth Audio CODEC | SBC |
Transmitting Power | Specification Power Class 2 |
Line of sight range | 10meters / 30feet |
The frequency and maximum transmitted power: 2402MHz ~ 2480MHz: 1.3dBm (bluetooth EDR) | |
Built-in Battery | |
Battery: | Rechargeable Lithium-ion battery 18650 3.63V 2600mAh |
Play time: | When normal operation, speaker output power is 10mW (Max. up to 1.7W). BT Band is 36Hr. FM Band is 22Hr. |
Charge time: | approximately 6.0Hr |
Standby time: | approximately 4.5Months |
Operating temperature range: | 0°C to +35°C |
|
|
Sangean reserves the right to amend the specifications without notice.
If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the EUPHONIC 45X that isn't answered in the manual? Leave your question here.