Konig SAS-ASRC240 - Remote Control Manual

Table of Contents

Remote control

Overview

	Arming mode	Press the button to fully arm the alarm system (away mode).
	Disarming mode	Press the button to disarm the alarm system.
	Partial-arming mode	Press the button to partially arm the alarm system (Stay mode). Note: the devices defined by Stay mode will not be armed. Please refer to the user manual of SAS-ALARM240 for details.
	Emergency	Press the button to activate an emergency alarm. The control panel dials the preset phone number automatically.

Pairing the remote control to the control panel • Open the settings menu on the control panel.

Open the settings menu on the control panel.
Please press # 08 <xxx> #, whereas <xxx> represents a number between 001 and 120 Please refer to the user manual of SAS-ALARM240 for details.
Press a button on the remote control.
2 beeps = pairing successful.
1 beep = remote control already paired.

RISK OF ELECTRIC SHOCK
DO NOT OPEN

To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
Disconnect the product from the mains and other equipment if a problem should occur.
Read the manual carefully before use. Keep the manual for future reference.
Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.

Do not use cleaning solvents or abrasives.
Do not clean the inside of the device.
Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
Clean the outside of the device using a soft, damp cloth.