Operating The Speed Selector; Operating The Auger/Impeller Drive - Toro Power Max 724 OE Manual

Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (Figure 19). The lever locks in a notch at
each speed selection.
Figure 19
Operating the
Auger/Impeller Drive
1. To engage the auger/impeller drive, squeeze
the right (auger/impeller) lever to the handgrip
(Figure 20).
Figure 20
2. To stop the auger and impeller, release the right
lever.
Important:
When you engage both the
auger/impeller lever and the traction lever,
the traction lever locks the auger/impeller
lever down, freeing your right hand. To
release both levers, simply release the left
(traction) lever.
3. If the auger and impeller continue to rotate when
you release the auger/impeller lever, do not
operate the machine. Check the auger/impeller
cable; refer to Checking and Adjusting the
Auger/Impeller Cable (page 21)
necessary. Otherwise, take the machine to an
Authorized Service Dealer for service.
g001012
g001013
and adjust it if
16
WARNING
If the auger and impeller continue
to rotate when you release the
auger/impeller lever, you could seriously
injure yourself or others.
Do not operate the machine. Take it to an
Authorized Service Dealer for service.